This content can't be printed from the browser. Use Export PDF with Pro for an offline copy.
A goalkeeper activates skeletal muscles to catch a ball. Which substance is released from motor neuron endings to stimulate these muscles?
ATP
Acetylcholine
Calcium
Adrenaline
During a resistance exercise, a player slowly lowers a raised heel back to the floor. The calf muscles remain active and lengthen to control the descent. Which type of contraction occurs in these muscles?
Isometric
Isotonic concentric
Isokinetic
Isotonic eccentric
A player extends the elbow against resistance, with triceps brachii acting as the agonist and biceps brachii as the antagonist. Which response describes reciprocal inhibition during this action?
Activation of both triceps brachii and biceps brachii is reduced.
Activation of biceps brachii increases as activation of triceps brachii decreases.
Activation of biceps brachii is reduced as triceps brachii is activated.
Activation of both triceps brachii and biceps brachii increases equally.
A researcher examines motor-unit activation during a grip exercise. Which statements about the all-or-none principle are correct?
I. A motor unit does not contract if stimulation remains below its threshold.
II. When its motor neuron activates, the muscle fibres belonging to that motor unit respond together.
III. Once one motor unit reaches its threshold, all motor units in the muscle must contract.
I and II only
I and III only
II and III only
I, II and III
Build a Practice Exam — Sports Science HL
Test your knowledge with a custom paper containing questions from selected topics.


A cyclist progressively increases pedal force from a very low level to near-maximal effort. Which pattern of motor-unit recruitment would normally be expected as the force requirement increases?
Type I units are recruited first, followed by the addition of type IIa and then type IIx units.
Type IIx units are recruited first, followed by the addition of type IIa and then type I units.
Type I units are recruited first, then switched off as type IIa and type IIx units replace them.
All three types are recruited initially, followed by increased force from each individual motor unit.
During a rower's muscle contraction, a myosin head remains attached to actin immediately after its power stroke. What directly causes this myosin head to detach from actin?
Calcium binding to troponin
ATP hydrolysis by the myosin head
ATP binding to the myosin head
ADP release from the myosin head
A sports scientist investigated elbow-flexor force in recreational kayakers. One group performed maximal isotonic concentric elbow flexion and a different group resisted elbow extension using maximal isotonic eccentric contractions of the elbow flexors. Each group contained 16 kayakers. A dynamometer measured peak force using the same joint range and movement speed for both groups.
Table 1 summarizes the results.
Table 1. Peak elbow-flexor force during maximal isotonic contractions.
| Contraction type | Sample size, | Mean peak force / N | Standard deviation / N |
|---|---|---|---|
| Isotonic concentric | 16 | 240 | 30 |
| Isotonic eccentric | 16 | 310 | 35 |
Interpret the results in Table 1 in relation to contraction type.
The eccentric group had completed substantially more resistance training before the investigation. Explain how this uncontrolled difference could affect the interpretation of the results.
Evaluate the suitability of an independent-samples t-test for comparing the peak forces of the two groups.
A wheelchair basketball player trains the elbow flexors using a motor-controlled resistance device. Figure 1 shows the equipment and its feedback screen during two elbow-flexion repetitions. The upper arm is supported throughout the movement.
Explain how the device produces isokinetic exercise despite the different forces shown for the two repetitions in Figure 1.
Outline how reciprocal inhibition assists elbow flexion during the exercise. Refer to biceps brachii and triceps brachii in section 9 of the data booklet.
The player claims that the higher force in the second repetition contradicts the all-or-none principle. Discuss this claim.
State the neurotransmitter that stimulates skeletal muscle contraction and the molecule whose breakdown supplies immediate energy for contraction.
Build a Practice Exam — Sports Science HL
Test your knowledge with a custom paper containing questions from selected topics.


After several weeks of reduced activity, a hockey player has muscle atrophy and a lower maximum force capacity. The player resumes an exercise using the same external load as before. Which change is most likely when completing this task?
The load represents a smaller proportion of maximum capacity, requiring less motor-unit recruitment.
The load represents the same proportion of maximum capacity, leaving motor-unit recruitment unchanged.
The load represents a greater proportion of maximum capacity, potentially requiring greater motor-unit recruitment.
The load represents a greater proportion of maximum capacity, requiring type IIx units to be recruited before type I units.
In a laboratory investigation of muscle function during exercise, calcium is released normally within a stimulated muscle fibre but is prevented from binding to troponin. ATP remains available. Which outcome is most likely?
Myosin heads cannot detach because calcium must bind to myosin before ATP can act.
Actin filaments shorten because calcium can bind directly to their exposed ends.
Cross-bridge cycling proceeds normally because ATP alone exposes the binding sites on actin.
Cross-bridge formation is inhibited because tropomyosin continues to cover the binding sites on actin.
Researchers investigated calcium regulation of muscle force using small muscle samples donated by adult sprint canoeists during an ethically approved investigation. The membranes of isolated fibre preparations were made permeable so that the surrounding solution could control calcium and ATP availability.
One preparation from each donor was randomly allocated to either a low-calcium or a high-calcium solution. Both solutions contained ATP. Fibre dimensions, initial sarcomere length and temperature were standardized. The preparations were held at a fixed length, and a force sensor recorded active force after subtracting resting force.
Table 1 shows the results for eight independent preparations in each condition.
Active force of permeabilized muscle-fibre preparations in solutions with different calcium concentrations.
| Solution | Mean active force / mN | Standard deviation / mN | |
|---|---|---|---|
| Low calcium | 8 | 20 | 8 |
| High calcium | 8 | 80 | 20 |
Interpret Table 1 using the sliding filament theory.
A subsequent check showed that ATP availability was lower in the low-calcium solution and limited repeated cross-bridge cycling. Explain how this affects the conclusion about calcium.
The researchers used the same calibrated force sensor and mounting procedure for all preparations, but recorded only one activation per preparation. Evaluate the reliability of this measurement method.
A badminton player performs a controlled dumbbell curl during strength training. Figure 1 shows the elbow flexion angle during one repetition. An angle of zero represents a fully extended elbow. The upper arm remains stationary throughout the repetition.
Describe the type of contraction performed by the biceps brachii in each of phases A, B and C in Figure 1.
Explain the changes in the widths of the I band and A band as a sarcomere in the biceps brachii shortens during phase A. Use section 11 in the data booklet.
Explain how calcium released from the sarcoplasmic reticulum enables myosin to pull actin during phase A.
The player repeats the exercise with progressively heavier dumbbells. Outline the usual order of recruitment of type I, type IIa and type IIx motor units as force requirements increase.
Outline reciprocal inhibition between the biceps brachii and triceps brachii during phase A.
After the repetition, stimulation of the biceps brachii stops. Explain two ways in which a complete absence of ATP would prevent normal muscle relaxation.
Build a Practice Exam — Sports Science HL
Test your knowledge with a custom paper containing questions from selected topics.


Sports scientists investigated whether real-time muscle-activation feedback could help climbers increase maximal isometric pulling force. Surface electrodes produced an activation trace that climbers could view while pulling on a fixed climbing hold. A separate force sensor measured their pulling force.
Peak isometric pulling force for one climber in two sequential trials.
| Trial order | Condition | Peak force / N |
|---|---|---|
| 1 | No feedback | 480 |
| 2 | Real-time feedback | 552 |
In a preliminary trial, one climber performed one maximal pull without feedback, followed by one maximal pull with feedback. The elbow angle was kept constant. Table 1 shows the results. Calculate the percentage increase in peak force when feedback was provided.
Explain two reasons for keeping elbow angle constant when comparing the climber's peak forces.
Explain two weaknesses of the preliminary trial and their effects on the conclusion.
A regional climbing centre kept annual records for its standardized maximal isometric pull test. Real-time activation-feedback training became available at the centre at the start of 2018. Figure 1 shows the annual record forces and a straight line of best fit. Discuss whether the records support the hypothesis that introducing feedback training increased record force.
Evaluate the suitability of the straight line of best fit in Figure 1.
A second study randomly allocated 40 climbers to either six weeks of training with real activation feedback or identical training with a prerecorded trace unrelated to their own activation. Participants were told that both displays provided useful feedback. Before and after training, peak force was measured without feedback using the same fixed hold, elbow angle and calibrated force sensor. The mean of three maximal pulls was used, with a standardized rest interval between pulls. Evaluate the reliability of this force measure.
Figure 2 shows mean peak forces before and after training. Analyse the results in relation to the effectiveness of real activation feedback.
Outline how an expectation effect could contribute to improvement in the prerecorded-feedback group.
Suggest two additional procedures that would reduce bias in the second study.